Siemens Hicom 150

From Call Accounting Wiki

Categories: Siemens | Pbx

Siemens Hicom 150 Series

Informations from this page are valid for all models including: Hicom 150, Hicom 150 E (150E), Hicom 150 H OfficePoint, Hicom 150 H OfficePro, Hicom 150 H OfficeCom.

In OfficeCom OfficePoint, the V24/2 module provides two serial V.24 (RS-232) interfaces for connecting a PC, a printer, or Plus Products (such as Uniform Call Distribution). The V24/1 (not for U.S.) is an under equipped version with only one V.24 (RS-232) interface.

Interfaces: V24 Interfaces (S30807-Q6916-Xxxx) Note: We recommend setting up call detail recording central (CDRC) on interface X2 of OfficeCom and OfficePoint (software configuration required) if a V24/2 module is installed.

Use a shielded 9-pin cable as a connecting cable. The wires must be twisted and have a diameter of at least 0.5 mm (24 AWG). The integrated wire shielding must be soldered onto the connector and socket housing of both cable ends. Short-haul modems must be provided if the cable length exceeds 15 m (50 ft.).

Pin Assignment of the 9-Pin Socket and 25-pin Connector on the V.24 (RS-232) Cable for OfficePro
9-Pin Sub-D Socket 	25-Pin Sub-D Connector 	Signal
1 	8 	DCD (Data Carrier Detect)
2 	3 	RxD (Receive Data)
3 	2 	TxD (Transmit Data)
4 	20 	DTR (Data Terminal Ready)
5 	7 	GND (Signal Ground)
6 	6 	DSR (Data Set Ready)
7 	4 	RTS (Request To Send)
8 	5 	CTS (Clear To Send)
9 	22 	RI (Ring Indicator)

Cable V24/1 (Not for U.S.) and V24/2

Connector Assignment V.24 (RS-232) Contact Assignments, OfficeCom and OfficePoint