Alcatel 4200 E

From Call Accounting Wiki

Categories: Pbx | Alcatel

Alcatel 4200 E

You have to do the following settings using your Alcatel programming software (MMC).

If you don't have a cable you'll need to make the wiring directly on the CM board.

Connect X7, X8 : 10 pin BURNDY connector for connecting a pulse metering device (X7) and the MMC PC (X8). The terminals connected to these interfaces must be classified S.E.L.V.

Pin no.	Signal	Function
1		REMOTE		Signal used for remote access
2		RXD 		104 - Reception
3		TXD 		103 - Transmission
4		DTR 		108 - Data Terminal Ready
5		0V 		Ground
6		DCD		109 - Carrier Detection
7		RTS		105 - Request To Send
8		CTS		106 - Clear To Send
9		0V		Ground
10		GND		102 - Signalling Ground